About the introduction of PV pier mold, the PV pier produced is generally prefabricated, which is a common production method, because the quality of the products produced is relatively high, and transporting the PV pier to the construction site can speed up the construction speed of workers and reduce the construction time, In this way, the impact on local traffic is relatively small. The operation of this kind of mold is relatively detailed when making, so the surface of the produced photovoltaic pier is very smooth, and the service life is relatively long. Our photovoltaic piers are mainly used in the construction of photovoltaic power generation facilities and play a very important role. These projects have relatively high quality requirements for photovoltaic piers, so they use prefabricated photovoltaic piers. We generally use the photovoltaic pier mold in the production of this kind of photovoltaic pier, and the use method is the same as that of other molds. If the applied construction projects are different, the specifications and sizes of the PV pier molds required are also different. Before production, the molds of the injection molding machine should be replaced with the sizes we need. The molds we have made can not be directly sold to customers. Their quality needs to be tested in order to ensure our reputation.
PV pier molds are produced in the prefabrication plant. The prefabrication plant is divided into several sites, including the site for producing prefabricated parts, the site for storing prefabricated parts and the site for storing molds. The following is a brief introduction to the operation steps of molds. When the cast-in-situ vibration platform is prepared, clean up the sundries on it, and then brush the oil while placing the mold on the platform. The position on the mold that needs to be painted is not only the inner bottom surface, but also the inner wall. From the dimension of the upper and lower parts of the mold, there is a taper, which should be considered for all plastic molds. You can use the spade or the flat shovel to load the cement into the six corner plate mold, then fill all the mold on the vibrating platform and then open the vibrating platform, because the volume of the collision avoidance is relatively small, so it can be vibrated after dozens of seconds. The PV base molds are designed with taper to facilitate demoulding, so that when the cement in the mold is completely air dried and the mold is buckled, the inner hexagonal plate can be more easily separated from the mold. The oil brushing step is also to reduce the adhesion between the cement and the mold and enhance the smoothness, but try not to use waste oil, Waste oil may cause the color of preforms to change.